iPhone Fault Finder

Board-level diagnosis assistant Β· iPhone 6 β†’ iPhone 17 series

Connect iPhone β€” verification report

Connect the iPhone with a cable β†’ unlock it β†’ tap Trust β†’ Scan.

Problem β†’ solution

DC power supply (ammeter) reading

Setup: Battery removed. Connect the supply to the battery connector (or a boot cable): red to battery +, black to ground. Set 4.2 V with a low current limit (start β‰ˆ1 A) so a shorted board can't burn. Watch the current before and after pressing power (or shorting the power-on trigger).

Quick presets

Enter your readings

iTunes / Finder / 3uTools restore error codes

Before calling any error "hardware": use an original/known-good cable, a rear USB port, the latest iTunes/Finder or 3uTools, a different computer, and try DFU mode β€” not just recovery mode.

Panic log analyzer

Where to get it: Settings β†’ Privacy & Security β†’ Analytics & Improvements β†’ Analytics Data, open the newest panic-full-… file, or export it with 3uTools (Toolbox β†’ Crash/Panic logs). Paste the whole text below.

Line check (diode / resistance mode)

How to measure

  1. Battery and all flexes disconnected. Never measure diode values on a powered board.
  2. Meter in diode mode. Usual repair-shop method: red probe on ground, black probe on the line (test point, capacitor or connector pin). Stay with one method so your numbers compare.
  3. Read the value: 0.000–0.010 = short to ground Β· OL = open line (broken track / missing pad / dead component) Β· anything else = compare to a known-good board.
  4. Compare against a good board of the same model, or a schematic/boardview tool (ZXW, WUXINJI, Borneo, etc.). Differences of more than ~10–15% are suspect.
  5. A short found? Inject low voltage on that line (start 0.5–1 V, current-limited, never above the line's own voltage), then find the hot part with freeze spray, rosin smoke or a thermal camera.

Lines to check first

LineWhereCheck when
VDD_MAIN / PP_VDD_MAINBattery connector +, big caps near PMUDead phone, leakage, short on ammeter
PP_BATT_VCCBattery connector, battery FETDead, no boot on battery but boots on supply
VBUS / PP5V0_USBCharging port / Lightning or USB-C connectorNot charging, not detected by computer
USB D+ / Dβˆ’ (DP/DN)Charging connector β†’ Tristar/Hydra / USB ICCharges but no iTunes/3uTools, error 9, 2009, 4013
PP1V8 / PP1V8_ALWAYSPMU outputs, many capsStuck at low current, no boot
PP_CPU / PP_GPU / PP_SOCBuck outputs around CPUCurrent stuck, heats near CPU
LCM / display connector pinsScreen FPC connectorNo display, lines, backlight off (LCD models)
Touch / Face ID / camera connector pinsRespective FPC connectorsFunction dead after drop or liquid
Line names vary by model and schematic version. Always confirm the exact net name in the boardview for that board.

My reference values (saved on this device)

Job notes

Saved reports (server)

☁️ Shop server